TM 11-5815-602-10
EE161-DM-OPI-010/E154UGC74
TO 31W4-2UGC74-1
NOTES
planation of abbreviations and symbols, and to the ERROR MESSAGE
LIST, table J-2 in Appendix J, for the explanation of error
messages by number.
2. The printed symbol for PARAMETER command is a dash (--).
LINE SUBCOMMAND
G-1.
This subcommand allows the operator to select the length of the text line. On power-up in-
itialization. the line Iength is set at 80. If no value is selected, 80 is used. The value selected must
be between 40 and 80, & error message number 10 is printed out, and the subcommand ter-
minated.
a. The keystroke sequence for the LINE subcommand is either:
(1) b0LINE ( + b2XX) b0CR (XX represents the line length figure).
(2) b0LINE CR (if no value is input, the system recognizes the value as 80).
b. The shortest acceptable form of the subcommand is LIN.
c. Operator example: Having entered the PARAMETER command Ievel in paragraph 2-14b,
the operator decides to set the text line length at 60. The operator knows from the prompt
sequence print-out (CR/LF - CR/2LF), that the system is ready to accept the LINE subcom-
mand as follows:
Previous Page
