TM 11-5815-602-10
EE161-DM-OPI-010/E154UGC74
TO 31W4-2UGC74-1
CORRECTIVE ACTION
Step 1. Check to see if illumination control is set in OFF position.
Turn control knob toward BRIGHT position.
Step 2. Check to see if lamp(s) is defective (para 3-7).
Replace lamp(s); notify organizational maintenance if problem is beyond
operator capability.
Step 1. Check to see if ILLUM control is in OFF position.
Adjust ILLUM control as required.
Step 2. Check for defective lamp(s).
Perform lamp test by pressing and holding the PARITY RESET switch which
will cause a lamp test to be performed on all lamps. Replace lamp(s) (para
Check to see if audio control is in the OFF position.
Adjust audio control towards MAX position. Notify organizational maintenance
if alarm still cannot be heard.
Step 1. Check to see if terminal is low on paper (PAPER LOW lamp is on).
Replace paper if required (para 3-5).
Step 2. Check to see if terminal is in PAPER command.
Enter GO CR. If print drum does not rotate, notify organizational maintenance.
3-3
Previous Page
