TM 11-5815-602-10
EE161-DM-OPl-010/E154UGC74
TO 31W4-2UGC74-1
NOTE
The following example, paragraphs c and d below, is for a typical terminal
installation. The operator normally receives preset instructions from the
Electronics Operation Instructions (COEI).
c. In the following example, the terminal is installed in a link having the following
requirements:
Parity: Odd
q
q State: RO, KSR, or ICT, depending on the requirement.
interface: LO DATA
q Data format: NRZ
Transmission speed: 1200 Baud
q Communication
clock source: Internal
q Clock edge: Positive (+)
q Figure S/J: Not applicable in ASCII
q Data input: Noninverted data
q No. of stop bits in data format: Two
q Data
character set: ASCII
d. With the terminal fully extended on its slides, perform the following initialization setup
procedure for the above example.
Be sure the rear connecting cables feed through the terminal rear access
door with a minimum of strain.
2-48