Figure 3-6. Normal connections for order-wire circuit operation and TD-206/G tests.
WARNING
(2) To connect the TS1323/PTM-7 for order-
Before handling cable, be sure the operator
wire operation at a TD-206/G location, connect the
has removed power from the faulty link (ca-
TD-206/G and the two CX-4245/G's to the
ble driver power switch at 00.
TS-1323/PTM-7 as shown in figure 3-6.
(a) Strip the outer insulation from the
NOTE
CX-4245/G to expose about 1 inch of the inside
braided sheath and the center conductor.
These connections should be made only to a
(b) Connect the center conductor of the
link known to be faulty. Making these con-
CX-4245/G to red EMERGENCY OW binding posts
nections to an active link will disrupt service.
11 and 13.
(3) If the cable is cut or the connectors are
(c) Connect the braided sheath from both
broken, refer to figure 3-7 and connect the
strands of the cable to black EMERGENCY OW bind-
ing post 12.
TS-1323/PTM-7 as follows:
Change 4
3-8
Previous Page
