TM 11-6625-596-12
CHAPTER 2
OPERATION
Section I. SERVICE UPON RECEIPT OF EQUIPMENT
(5)
Remove the envelopes that contain the
2-1. Unpacking
manuals.
a. Packaging Data. The TS-716 is packaged in two
shipping boxes. The first box contains the test set and
(6)
Remove the pads.
the second box contains an adaptor and cables required
to connect the equipment under test to the test set. A
(7)
Remove the equipment.
2-2. Checking Unpacked Equipment
Box 1. The test set Is placed in a
(1)
corrugated carton and packed in a wooden shipping box.
a. Inspect the equipment for damage incurred
The dimensions, volume, and weight of box 1 are as
during shipment. If the equipment has been damaged,
follows:
report the damage on DD Form 6 (para 1-3b).
Dimensions
Volume Weight
b. See that the equipment is complete as listed on
Content
(in)
(cu It) (Ib)
the packing slip. If a packing slip is not available, check
the equipment against the basic issue items list (app B).
Telephone Test
18 1/8 x 23
46
106
Report all discrepancies in accordance with TM 38750.
Set TS-716/U
1/2 x 18 3/4
Shortage of a minor assembly or part that does not affect
proper functioning of the equipment should not prevent
Box 2. The adaptor plate and ten cables
(2)
use of the equipment.
are packed in a corrugated carton and placed in a
wooden shipping box.
c. If the equipment has been used or
reconditioned, see whether it has been changed by a
b.
Removing Contents.
modification work order (MWO). If the equipment has
been modified, the MWO number will appear on the front
(1)
Cut and fold back the metal straps.
panel, near the nomenclature plate. See that any
operational instruction changes resulting from the
CAUTION
modification have been entered in the equipment
manual.
Do not attempt to pry off the top and
sides; equipment damage may result.
d. Remove the chassis from the transit case to
check for damage.
(2)
Remove the nails from the top and one
(1)
Remove the powerline plug from the clip
side of the box with a nailpuller. Remove the top and
side.
(2)
If the loudspeaker and microphone
cables (fig. 1-2) are connected, remove them from jacks
(3)
Remove the carton from the wooden box.
(4)
Open the carton. Be careful when cutting
through the sealing tape; cut only to the depth needed to
sever it.
2-1