TM 11-5815-602-10
EE161-DM-OPI-010/E154UGC74
TO 31W4-2UGC74-1
Be careful when sliding chassis back in case to ensure that the cables
feed back through the terminal rear access port with a minimum of
strain.
Slide the chassis back into the case.
Secure it in place with the latches.
q
NOTE
At this point, if paper was being changed in KSR or RO, roll paper
loading procedures will be completed after performing the following:
Apply power.
Perform manual line feed.
Verify that paper is feeding properly.
NOTE
If loading paper procedures are being performed while system is in ICT
state, the following must be done to complete the roll paper loading pro-
cedures:
Perform a manual line feed.
q
Verify that paper is feeding properly.
q
Input GO CR subcommand.
Print drum and ribbon-feed will turn on.
3-16
Previous Page
