TM 11-5805-371-20P
SECTION I
INTRODUCTION
1.
Scope
This manual lists repair parts; special tools; and other support equipment required for performance of organizational
maintenance of the Terminal Set , Telephone AN/TCC-65.
2.
General
This Repair Parts and Special Tools List is divided into the following sections:
a.
Section II. Repair Parts List. A list of repair parts authorized for use in performance of maintenance. The
list also includes parts which must be removed for replacement of the authorized parts. Parts lists are composed of
functional groups in ascending numerical sequence , with the parts in each group listed in figure and item number
sequence.
b.
Section III. Special Tools List. Not applicable.
c.
Section IV. National Stock Number and Part Number Index. A list , in ascending National item identification
number (NIIN , last 9 digits) sequence , of all National stock numbers appearing in the listings , followed by a list , in
alphameric sequence , of all part numbers appearing in the listings. National stock number and part numbers are cross-
referenced to each illustration figure and item number appearance.
3.
Explanation of Columns
The following provides an explanation of columns found in the tabular listings:
a.
Illustration. This column is divided as follows:
(1) Figure number. Indicates the figure number of the illustration in which the item is shown.
(2) Item number. The number used to identify each item called out in the illustration.
b.
Source , Maintenance , and Recoverability Codes (SMR ).
(1) Source code. Source codes are assigned to support items to indicate the manner of acquiring support
items for maintenance , repair , or overhaul of end items. Source codes are entered in the first and second positions of
the Uniform SMR Code format as follows:
Code
Definition
PA -
Item procured and stocked for anticipated or known usage.
PD -
Support item , excluding support equipment. procured for initial issue or outfitting and stocked only for
subsequent or additional initial issues or outfittings. Not subject to automatic replenishment.
XD
-
A support item that is not stocked. When required , item will be procured through normal supply channels.
NOTE
Cannibalization or salvage may be used as a source of supply for any items source coded above except
those coded XA , XD , and aircraft support items as restricted by AR 700-42.
(2) Maintenance code. Maintenance codes are assigned to indicate the levels of maintenance authorized
to USE and REPAIR support items. The maintenance codes are entered in the third and fourth positions of the Uniform
SMR Code format as follows:
(a ) The maintenance code entered in the third position will indicate the lowest maintenance level
authorized to remove , replace , and use the support item. The maintenance code entered in the third position will
indicate one of the following levels of maintenance:
Code
Definition
O
-
Support item is removed , replaced , and used at the organizational level.
(b) The maintenance code entered in the fourth position indicates whether the item is to be repaired
and identifies the lowest maintenance level with the capability to perform complete repair (i.e. , all authorized
maintenance functions). This position will contain one of the following maintenance codes:
Code
Definition
D
-
The lowest maintenance level capable of complete repair of the support item is the depot level.
F
--
The lowest maintenance level capable of complete repair of the support item is the direct support level.
Z
-
Nonreparable. No repair is authorized.
H
-
The lowest maintenance level capable of complete repair of the support item is the general support level.
1
Previous Page
