TM 11-6625-648-12
3-3. Starting Procedure
(1) Operate the METER SELECT switch to
a. Check the connectors on the TS-1323/PTM-7
BATTERY and hold. The meter should indicate in the
front panel; remove any accumulated dirt or water. Set
green zone or above. If it does not, replace the BA-30's
the front panel controls as follows:
(2) Release the METER SELECT switch.
Switch
Setting
3-4. Use of Pcm Probe
BATTER POWER . . . . . . . . . . . . . . . . . . . . . . . . . Pull out
OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . NORMAL
ORDERWIRE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . OFF
The pcm probe is used to check for the presence of pcm
DISTANCE TO FAULT . . . . . . . . . . . . . . . . . . . . o
signals at a TD-206/G in the link. An operating link
b. Check the battery voltage as follows:
will show normal pcm traffic; a faulty link will not. Use
Change 4
3-5