TM 11-6625-596-45
APPENDIX B
GENERAL SUPPORT AND DEPOT MAINTENANCE REPAIR PARTS
AND SPECIAL TOOLS LIST
Section I. INTRODUCTION
B-1
Scope
from GSA/DSA, or Army supply system and
authorized for use at indicated maintenance
This appendix lists repair parts required for the
categories.
performance of general support and depot maintenance
Code P2
-Repair parts which are procured and stocked
of the TS-716/U. No parts authorized for stocage at
direct support maintenance.
or military essentiality of the end item
dictates that a minimum quantity be
NOTE
available in the supply system.
No special tools, test, and support
Code P9
-Assigned to items which are NSA design con-
equipment are required.
trolled: unique repair parts, special tools,
test, measuring and diagnostic equipment
B-2
General
which are stocked and supplied by the Army
This repair parts list is divided into the following
COMSEC logistic system, and which are not
sections:
subject to the provisions of AR 380-41.
Code P10-Assigned to items which are NSA
design con-trolled: special tools, test,
parts authorized for the performance of mainte-nance at
measuring and diagnostic equipment, for
the general support and depot level.
COMSEC support, which are accountable
under the provisions of AR 380-41, and
b. Index-Federal Stock Number or Reference
which are stocked and supplied by the Army
Number Cross-Reference to Figure and Item Number or
COMSEC logistic system.
Reference Designation-Section III. A list of Federal
Code M
-Repair parts which are not procured or
stock numbers in ascending numerical sequence
stocked, but are to be manufactured in
indicated maintenance levels.
appearing in ascending alpha-numeric sequence
Code A
-Assemblies which are not procured or stocked
as such, but are made up of two or more
number and reference designation.
units.
Such component units carry
individual stock numbers and descriptions,
c. Index-Reference
Designation
Cross-
are procured and stocked separately and
Reference to Page Number-Section IV.
A list of
can be assembled to form the required
reference designations cross-referenced to page
assembly
at
indicated
maintenance
number.
categories.
Code X
-Parts and assemblies which are not procured
B-3
Explanation of Columns
or stocked and the mortality of which
normally is below that of the applicable end
The following provides an explanation of columns in the
item or component. The failure of such part
tabular lists:
or assembly should result in retirement of
the end item from the supply system. Code
a. Source, Maintenance, and Recoverability
X1 -Repair parts which are not procured or
Codes (SMR), Column 1:
stocked. The requirements for such items
(1) Source Code, indicates the selection
will be filled by use of the next higher
status and source for the listed item.
assembly or component.
Source codes used are:
Code X2
-Repair parts which are not stocked. The
indicated maintenance category requiring
Code
Explanation
such repair parts will attempt to obtain same
Code P
-Repair parts which are stocked in or supplied
B-1