TM 11-6625-596-12
APPENDIX D
ORGANIZATIONAL MAINTENANCE'REPAIR PARTS AND SPECIAL TOOLS LIST
Section 1, INTRODUCTION
(1) Source code indicates the selection status
D-1.
Scope
and source for the listed item. Source codes are-
This manual lists repair parts and special tools required
for the performance of organizational maintenance of
Code
Explanation
the TS-716/U.
F-
Applies to repair parts that are stocked in or
D-2.
General
supplied from the GSAIDSA, or Army Supply
This repair parts and special tools list is divided into the
System, and authorized for use at indicated
following sections:
maintenance categories.
P2-
Repair parts which are procured and stocked for
a. Prescribed Load Allowance (PLA) - Section
II. A composite listing of the repair parts, special tools,
military essentiality of the end item dictates that
test and support equipment having quantitative
a minimum quantity be available in the supply
allowances for initial stockage at the organizational level.
system.
b. Repair Parts - Section III. A list of repair
P9--
Assigned to items which are NSA design con-
parts authorized for the performance of maintenance at
trolled: unique repair parts, special tools, test
the organizational level.
measuring and diagnostic equipment, which are
c. Special Tools, Test and Support Equipment
stocked and supplied by the Army COM- SEC
-Section IV. Not Applicable.
logistic system, and which are not subject to the
d. Index - Federal Stock Number Cross
provisions of AR 380-41.
Referenced Figure and Item Number or Reference
P10-
Assigned to items which are NSA design con-
Designation - Section V. A list of Federal stock numbers
trolled: special tools test, measuring and
in ascending numerical sequence followed by a list of
diagnostic equipment for COMSEC support,
reference numbers in ascending alpha-
numeric
which are accountable under the provisions of
sequence, cross-referenced to the illustration figure
AR 380-41, and which are stocked and supplied
number and reference designation.
by the Army COMSEC logistic system. Repair
e. Index -- Reference Designation Cross
parts which are not procured or stocked, but are
Reference to Page Number Section VI. A list of
to be manufactured in indicated maintenance
reference designations cross-referenced to
page
levels.
number.
A-
Assemblies which are not procured or stocked
as such, but are made up of two or more units.
D-3.
Explanation of Columns
Such component units carry individual stock
numbers and descriptions, are procured and
The following provides an explanation of columns in the
stocked separately, and can be assembled to
tabular lists.
form the required assembly to indicated
a. Source, Maintenance, and Recoverability
maintenance categories.
Codes (SMR), Column 1.
X-
Parts and assemblies which are not procured or
stocked and the mortality of which normally is
below that of the applicable end item or
component. The failure of such part or
assembly should result in retirement of the end
item from the supply system.
X1-
Repair parts which are not procured or stocked.
The requirement for such items will be filled by
use of the next higher assembly or component.
D-1